A Black Cap protects the
hydraulic mechanism on
the Support Cylinder.
Place the wide end of
the Support Cylinder
into the center hole.
Place the Foot Cap over
the center hole on the
base plate.
Press the Support
Cylinder down firmly
into the center hole.
and press down
FIRMLY.
Press the Seat onto
the narrow end of
Support Cylinder.
Remove the Black Cap
and discard it before
assembly. The Orange
hydraulic button will
become visible.
ASSEMBLY INSTRUCTION
`
To raise and lower the Seat, grasp the Handle and pull upward without applying any weight on the
Seat. To lower, grasp the Handle and pull upward while sitting on the Seat.
To disassemble, turn the stool upside down, and hit
the clip on the center of the bottom of the base with
a rubber mallet to disengage the locking
mechanism. Then, turn the stool right side up, and
lift the Seat upward, pulling the Seat Assembly off
of the Support Cylinder.
Use allen wrench to
attach the Seat Plate
to the underside of the
Seat with the provided
4 SHORT screws.
Metal Clip
Use allen wrench
to attach the Back
Post to the Seat
with the provided 6
LONG screws.
