A Black Cap protects the
hydraulic mechanism on
the Support Cylinder.
Remove the Black Cap and
discard it before assembly.
The Orange hydraulic
button will become visible.
Place the Foot Cap
over the Footrest.
Insert the Support Cylinder
into the center of the Seat
Plate
Insert the Support
Cylinder into the center
hole of the Footrest
Press down firmly
on seat to secure
into base.
ASSEMBLY INSTRUCTION
To raise and lower the Seat, grasp the Handle and pull upward without applying any weight on the
Seat. To lower, raise the Handle upward by sitting on the Seat.
To disassemble, turn the stool upside down, and hit
the clip on the center of the bottom of the Footrest
with a hammer or mallet to disengage the locking
mechanism. Then, turn the stool right side up, and
lift the Seat upward, pulling the Seat Assembly off of
the Footrest.
To separate the Support Cylinder from the Seat,
gently strike the Seat Plate with a rubber mallet until
the Seat and Support Cylinder have separated.
MODEL BS2088C ROLLING CASTER WHEEL ASSEMBLY
If you have Model BS2088C, remove the Stationary Feet by unscrewing
each one and replace them with the Caster Wheels.
Use an allen wrench to attach the
Seat Plate to the underside of the
Seat with the provided Screws.
