Your STELLER has a powerful electric motor that is
located in the rear hub of the bicycle. If removal of the rear
tire is necessary you must first disconnect the power cable
that runs to the hub.
This can be done by pulling both ends of the cable in
opposite directions at the connector. When putting the
tire back on the connector has an arrow on each plug that
has to be aligned as you plug it in. If you do not have a
bike stand, put the bike on its side on a soft carpet and
remove the tire.
Do not put the bike upside down as it will damage the
throttle and display on the handlebars.
Your STELLER is equipped with a 7 speed Shimano Gear
System. The shifter is located on the right-hand side of the
handlebars. Lower gear numbers are used for climbing
hills and slower speeds. Upper gears are used for flatter
surfaces and faster speeds. Be sure you are pedaling while
changing gears. To shift gears up from 1 to 7 pull the shift
lever towards the grip with your index finger. To shift
gears down from 7 to 1 press the shift lever below the grip
with your thumb.
When looking at the sprocket on the rear hub you will
notice that when the shifter is in 1st position the chain is
on the largest sprocket.
When the shifter is in the 7th position the sprocket should
be on the smallest sprocket.
Occasionally the shifter gear number and sprocket
locations may not match. If this happens then the
derailleur needs an adjustment.
DISCONNECTING POWER TO
REAR MOTOR
GEARS
49/50
