21
© American Time
© American Time
20
SiteSync IQ Wired Installation Manual
SiteSync IQ Wired Installation Manual
Wired Clock Circuit Option
Glossar
y
App
endix
Tr
oublesho
oting
Clo
ck
Installation
Syst
em Contr
oller
Installation
Intr
oduction
Adjust Time Menu
Glossar
y
App
endix
Troublesho
oting
Clo
ck
Installation
Syst
em Contr
oller
Installation
Intr
oduction
Wired Clock Circuit Installation
To install wired clock circuits:
1. Disconnect and lock out power to the SiteSync IQ System Controller and any circuit wiring.
2. Remove the top cover from the System Controller.
a. Remove screws from each side of the cover.
b. Slide the cover up off the base of the unit.
3. Route signal circuit wires into the wiring compartment of the System Controller.
a. Remove knockout(s). See Appendix G for illustration showing knockout locations on the rear side of the unit.
b. Use copper conductors only.
c. Use strain relief connector fittings in the knockout holes to secure the wires.
d. Route the wires into the wiring compartment, leaving enough slack to make all connections to the relay terminals.
4. Connect clock wires to the circuit relay terminals
REAR OF SY
STEM C
ONTR
OLLER
COM
NO
NC
NC
COM
NO
CLOCK 1
CLOCK 2
1
2
Clock Circuit Terminals
Circuit LEDs
(red)
See Appendix I on Page 63 for Clock Circuit Wiring Diagram
The Adjust Time menu serves two functions:
1. Manual correction of impulse secondary clocks, and
2. Simple synchronization of the system controller to an external time source.
Adjust Time
Choose:
1=Adjust System Clks
2=Ethernet Sync Now
Adjust System Clocks
1=Calculated Adjust
2=Man. Adjust Impulse
0=Cancel
Calc Clock Adjust
Enter Time Shown
on secondary clocks
00:00
Adjust System Clocks
Manual Adj. Impulsed
>=Advance Clocks
(1 per min) OK=Done
u
Press:
9
to access the Adjust Time Menu
v
Press
1
to enter Adjust System Clocks Menu
w
Press
1
to bring up the Calculated Adjust screen
Enter the time shown on the secondary clocks (to the nearest minute).
The time entered should be in 12 hour format as AM/PM settings are
irrelevant.
Press
O
. The time difference between the secondary clocks and
the system controller is displayed.
Press
O
to initiate automatic correction of the secondary clocks
and return to the Adjust Time screen.
x
Pressing
2
in the Adjust System Clocks menu (#3 at right) brings
up the Manual Adjust screen.
Press
>
repeatedly to correct impulse clocks manually.
Press
O
when finished to return to the Adjust Time menu.
y
Pressing
2
in the Adjust Time screen (#2 above) causes the unit to
attempt synchronization with external time sources* in order of priority.
If successful, a message confirming this flashes before the Time
Display screen appears.
*The time sync priority can be configured. Reference Settings &
Configuration on Page 41.
2
3
3a
4
TUE JUL 03 2018
10:38:06 AM USCT
American Time
Status=AUTO ETH=Y
TUE JUL 03 2018
10:38:06 AM USCT
American Time
Status=AUTO ETH=Y