3
INSTALL HAND SHOWER
2
3
5
4
2
6
7
12
8
10
11
13
13
1
1
9
TEST INSTALLED DIVERTER
4
Turn DIVERTER VALVE
(1)
fully clockwise (Tub fill position).
Lift HANDSHOWER
(2)
from holder, direct spray into tub, turn
DIVERTER VALVE
(1)
fully counter-clockwise to check
HANDSHOWER
(2)
and HOSES
(3)
for leaks. With DIVERTER
VALVE
(1)
in counter-clockwise position, flow should only
come from HANDSHOWER
(2)
.
Turn control valves "off."
Turn on control valves and check all connections for leaks. With
DIVERTER VALVE
(1)
in clockwise position, flow should only come
from tub spout.
1
2
3
5
EverClean™ Finish Care Instructions
American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with
clean water may also be used, if desired. No additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
Unscrew the HOLDER
(1)
from the SHOWER ESCUTCHEON
(2)
. Slip the
SHOWER HOSE
(3)
through the SHOWER ESCUTCHEON
(2)
and the
HOLDER
(1)
.
Pull out the SLEEVE GUARD
(6)
and HOSE
(7)
. Unthread the SLEEVE GUARD
(6)
from the HOSE END
(8)
connection.
Be careful not to allow the HOSE
(7) to fall back through the SLEEVE (9).
Insert SEAL WASHER
(10)
into the SHOWER HOSE CONNECTOR
(11)
.
Thread the SHOWER HOSE CONNECTOR
(11)
onto the HOSE END
(8)
and
tighten securely.
Thread the SHOWER ESCUTCHEON
(2)
into the SLEEVE
(9)
until the
SHOWER ESCUTCHEON
(2)
contacts the finished deck.
Loosen the SET SCREW
(12)
in the SHOWER ESCUTCHEON
(2)
and rotate
the ESCUTCHEON
(2)
so that SET SCREW
(12)
faces the center of the tub.
Retighten the SET SCREW
(12)
.
Thread the HOLDER
(1)
into the SHOWER ESCUTCHEON
(2)
.
Insert a SEAL WASHER
(4)
into the SHOWER HOSE CONNECTOR
(5)
and hand tighten HAND SHOWER
(13)
into
SHOWER HOSE CONNECTOR
(5)
.
Place the HAND SHOWER
(13)
into the HOLDER
(1)
.
M 9 6 8 8 9 7