- 2 -
VANITY INSTALLATION
Unpack unit carefully, taking care that bottom shelf does not drop and damage front legs (
see Figure 2
).
Provide suitable reinforcement for anchoring the vanity to the wall. Centerline of reinforcement should be 33-1/2" up
from the floor (
see Figure 1
).
Rough in supply lines and waste per rough-in dimensions.
The molding needs to be notched to seat the vanity flush against the wall.
Move the vanity into place and level with the adjustable glides on the bottom of the feet.
The glides can be adjusted outward up to 1" but it is recommended not to exceed 1/2" if possible.
Drill at least two 3/8" O.D. anchoring holes through the centerline of the rear stringer of the vessel stand, located 3/4"
down from the top of the table (
see Figure 2
).
Anchor the vanity to the wall through at least 2 of the anchoring holes in the rear of the vanity (
see Figure 2
).
Continue with installation appropriate for top and sink options chosen.
A
B
After top is replaced, connect the trap to the drain assembly hand tight to check
alignment. It may be necessary to cut off part of the tailpiece (area "A") or part
horizontal leg of the trap (area "B").
Connect hot and cold supply lines to the shut off valves. Tighten trap joints for
watertight assembly.
7 7 0 0 1 3 - 1 0 0
C/L of 2 x 6
Reinforcement
Finished
Floor
FIGURE 1
FIGURE 2
ANCHORING HOLES
IN REAR STRINGER
[NOT SHOWN]
ADJUSTABLE
LEVELLERS
(under each foot)
FINISHED
WALL
4-1/4"
(108mm)
35-1/4"
(895mm)
22"
(559mm)
REAR STRINGER WITH
ANCHORING HOLES TO
SECURE VANITY TO WALL
33-1/2"
(851mm)