7 3 0 5 2 0 - 1 0 0 R e v . D
- 2 -
1A
1B
1
3
2
Slide Shelf Support (item #1) onto 4 leg
subassemblies.
Slide the 4 Upper Legs (item #4) onto the
Threaded Rods from the 4 leg subassemblies
as shown.
Remove lower leg
support / adjustable
foot assembly
(items 2 & 3) from
accessories box
and screw them
completely onto the
4 threaded rods
(item 5).
Unscrew the 2 front
leg trumpets (item
6) and 2 rear leg
trumpets (item 7)
from the threaded
rod (item 5).
Slide the 2 Towel Bar Assemblies (item #9) over the tops of the Trumpets
and secure with the 4 Towel Bar Retaining Nuts (item #10). The retaining
nuts can be tightened by hand.
Place the 2 Front Leg Grommets (item #12) over the tops of the 2 Front
Leg Trumpets.
NOTE: To prevent breakage, slide the Oval Glass Shelf (item #11) into
place
only after the lavatory and Console Legs are completely
assembled and the lavatory is bolted to the wall. Be sure to remove
protective film from glass shelf before final assembly.
CAUTION: Do not use towel bars as handles to move the console table.
Lift the console from the upper legs.
After console table is assembled, follow lavatory installation
procedure below.
Screw on the 2 Front Leg Trumpets
(item #6) and 2 Rear Leg Trumpets
(item #7). Make sure the Upper
Legs recess into the underside of
the Trumpets.
Provide suitable reinforcement behind finished wall for
lavatory hanger mounting screws. The desired rim height
for the Standard pedestal top is 36". The centerline for the
hanger positioning slots should be located at
30-3/4". (Make sure support bottom
extends to pedestal top back wall bottom.)
Hanger
Location
C/L of 2 x 8
Support
and Bracket
Finished
Floor
NOTE: If replacing an existing lavatory be certain to shut off
water supply before removing old lavatory.
30-3/4"
4
Threaded
Rod
Threaded
Rod
1
7
Rear
6
Front
12
10
9
6, 7
5
Front
PEDESTAL TOP AND CONSOLE TABLE LEG INSTALLATION
2
3
