SUGGESTED
INSTALLATION
METHOD
LEVELING SURFACE
WATERPROOF
SEALANT
BATH
TYPICAL INSTALLATION
A S D E S I R E D
SEE
CUTOUT
TEMPLATE
PROVIDED
A S D E S I R E D
19-1/4
(489mm)
ACCESS PANEL
12
(305 mm)
UNLESS AN ACCESS OPENING OF AT LEAST
12" X 24" (305 X 610 mm) IS PROVIDED,
WARRANTY SERVICE WILL NOT BE PERFORMED.
IT MAY BE NECESSARY TO
NOTCH DECK SURFACE TO
ACCOMMODATE WHIRLPOOL
ON/OFF SWITCH DURING
INSTALLATION
24
(610mm)
FRAMING AND INSTALLATION
The variety of installations possible for this bath may require framing procedures other than those
shown.
Locate studs as required. Insure rough dimensions are proper, plumb and square.
For whirlpools, provision must be made in all installations for an access opening for
servicing pump and controls.
The following procedure must be used for all installations: stringer or pier height should be as
indicated. The sump of the bath is supported by integral feet and
no
additional sump support is
required. Once the bath is in place, the feet should be shimmed accordingly, so that
the rim of the
bath contacts the stringer or pier but supports no weight
. Any finish material, such as tile or
wall board, must be self-supporting if it contacts the rim of the bath.
752878-100 Rev. E
(2)
SPIC AND SPAN® IS A REGISTERED TRADEMARK OF PROCTER & GAMBLE
IT MAY BE NECESSARY
TO NOTCH DECK SURFACE,
AS PUMP MAY PROJECT
BEYOND RIM OF BATH BY 1-1/2".