9
8
11
3mm HEX WRENCH
12
M 9 6 8 5 7 8 R e v . 1 . 1
4
TEST INSTALLED FAUCET
Unthread SPRAY HOSE
(3)
from SPRAY
(2)
.
Turn on water supplies and check connections for leaks
.
Hold HOSE END
(3)
in sink and operate HANDLE
(1)
on and off,
hot and cold to flush water lines thoroughly. Replace SPRAY
(2).
Pull SPRAY
(2)
out and check hose and supply connections
for leaks. Check that SPRAY HOSE
(3)
and WEIGHT
(4)
slide
up and down freely and do not interfear with supplies or waste
outlet plumbing. With faucet on turn SPRAY TOP
(5)
to spray
and aerator fuctions.
Check all drain connections for leaks.
Move HANDLE
(1)
to "off" position.
1
2
5
3
3
4
Loosen and remove LEVER HANDLE
(1).
Loosen HANDLE
SCREW
(2)
with 2.5mm Hex Wrench and then pull HANDLE
BASE
(3)
off.
Unthread ESCUTCHEON CAP
(4)
. Unthread the
CARTRIDGE NUT
(5)
.
Remove CARTRIDGE
(6)
. Clean inlets of CARTRIDGE
(6)
and MANIFOLD
(7)
.
Reassemble CARTRIDGE
(6)
. Replace CARTRIDGE
NUT
(5)
, CAP
(4)
and HANDLE assembly, check flow.
SERVICE
Clogged CARTRIDGE outlets or inlets may cause reduced
flow.
To clean, first turn off water supply then:
5
6
HOT & COLD SUPPLIES
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
1
2
3
4
5
6
CLEAN
7
Move HANDLE
(1)
into "off" position.
If SPOUT (11) leaks at swivel point the O-RINGS (12) need
to be replaced. To remove SPOUT (11)
:
Disconnect SPRAY HOSE
(8)
from CONNECTING NUT
(9)
.
Loosen the SPOUT SET SCREW
(10)
with a 3mm Hex wrench.
Rotate the SPOUT
(11)
side to side while pulling upward to
remove SPOUT
(11)
from faucet body. Remove SPRAY HOSE
(8)
.
Replace the defective parts and grease O-RINGS
(12)
. Replace SPRAY
HOSE
(8)
. Push SPOUT
(11)
back into position. Tighten SET SCREW
(10)
.
Reconnect SPRAY HOSE
(8)
to CONNECTING NUT
(9)
.
Check that SPOUT
(11)
rotates freely and does not leak
at the swivel point.
REMOVE
INSTALL
10
