7 9 1 4 0 7 - 1 0 0
© A M E R I C A N S T A N D A R D I N C . 2 0 0 5
• Place one anti-shake and then one flat washer on two long and two short screws. (Extra included in pack.)
• Position the rack under the sink and secure in place with the screws. Fig.5
• Gently tighten the screws.DO NOT OVER TIGHTEN THE SCREWS AS THIS MAY BREAK THE WELD NUT
• If a clip is not tight on the wire, remove the screw and add more flat washers until the clip grips the wire. Fig.7.
5
3
4
Long Screws
Long Screws
Short Screws
Short Screws
Flat Washers
Clips
Anti-shake Washer
Fixing Screw
Hole Locations
Fig.5
Fig.4
Fig.6
Fig.7
Note: The long screws go to the right hand side (outer edge) and the short screws go to the left hand side (center)
when looking from the front. Fig.6
