American Standard Edgemere 204AA Series, Installation Instructions Care And Maintenance, Page: 4 / 5

7302406-100
- 4 -
9
FLUSH BUTTONS ON TANK
Pressing both buttons at once will flush the low flush amount of 1.0 gal/flush or 3.8 L/flush. The
Lite Flush Button (with 3 dots)
should line up over the
blue actuator on the flush tower in the tank. The Full Flush Button (with 9 dots) should line up over the
white actuator on the flush tower in the tank.
WATER LEVEL
ADJUSTMENT KNOB
FLUSH
VALVE
LITE FLUSH
ADJUSTMENT
FULL FLUSH
ADJUSTMENT
BAYONET RELEASE
PUSH BUTTON
SILICONE SEAL
REFILL TUBE
WATER SUPPLY LINE
FILL
VALVE
Lite Flush Button (with 3 dots) for liquid waste.
1.0 gal/flush
3.8 L/flush
Full Flush Button (with 9 dots) for solid waste.
1.6 gal/flush
6 L/flush
TIPS:
If the bowl still does not flush properly after following the steps outlined in the troubleshooting guide, remove the tank lid and push one
of the flush buttons on top of the flush valve in the tank. If the flush appears to be normal, you will need to adjust the length of the
threaded rods for the push buttons mounted on the tank lid with the settings as follows:
1. Turn the lid upside down.
2. Loosen the black plastic lock nut.
3. Adjust the white threaded rod one turn counterclockwise.
4. Re-tighten the black plastic lock nut.
5. Put lid back on tank and test the flush. If it is still not flushing properly, repeat steps 1 through 4 until the problem is resolved.
6. If one counterclockwise turn is too much and causes the flush valve to stay open, adjust 1/2 turn clockwise and return to step 4.
FILL V
AL
VE
OR
W
ATER CONTR
OL
FLOAT
CUP
B
SET WATER
LEVEL HERE
WHITE
THREADED ROD
BLACK PLASTIC
LOCK NUT
BLACK PLASTIC
LOCK NUT
BLUE
THREADED ROD
ADJUSTMENTS
a. Adjust water level. Water level should be
adjusted to level indicated on tank by adjusting
float cup using water level adjustment knob.
b. Flush Valve Setting Adjustments:
Without
Liner
Tank
Full Flush
Adjustment
Lite Flush
Adjustment
2
2.5
Flush Valve
Setting
Adjustments
NOTE: All other settings will result in either more
or less water and are not recommended.
• To remove Flush Valve, apply slight
downward pressure and twist it until the
flush valve disengages from the bayonet.
• To reinstall Flush Valve, reverse the
above procedure.
DUAL FLUSH