- 4 -
M965530 Rev. 1.2
CHECK OPERATION OF POP-UP
MAKE WATER SUPPLY AND WASTE CONNECTIONS
•
Thread CABLE CONNECTOR
(1)
clockwise
onto DRAIN BODY CONNECTION
(2)
and
hand tighten.
Fig.
A.
Your new POP-UP DRAIN installation is
now complete.
Fig.
B.
Note:
Tailpeice on pop-up drain is
1-1/4" (32mm) O.D.
Fig.
B.
ATTACH CABLE CONNECTOR
1-1/4" O.D.
(32mm)
•
Operate LIFT KNOB
(1)
to verify that STOPPER
(2)
opens and closes.
Note:
If STOPPER
(2)
does not open and close properly then
refer to the “troubleshooting section” of these instructions.
1
APPROX.
20" (508mm
)
2
COLD
HOT
3/8" COMPRESSION
•
Connect FLEXIBLE SUPPLIES
(1, 2)
directly to wall supplies.
SUPPLY HOSE
(1)
(Marked with a Red Band) to the Hot wall valve
and SUPPLY HOSE
(2)
(Marked with a Blue Band) to the
Cold wall valve.
•
Faucet supplies are 20" long from faucet base.
Note: If additional supply length is required, installer must
purchase additional parts separately.
Important: If SUPPLY HOSES
(1, 2)
are to long, loop as
illustrated to avoid kinking.
•
Connect 1-1/4" (32mm) O.D. tailpiece on POP-UP DRAIN
to waste outlet.
1
Fig.
A.
Fig.
B.
1
2
2
1
7
8
9
