- 2 -
2
M965796 Rev. 1.0 (11/18)
• Turn off hot and cold water supplies before beginning.
• Connect FLEXIBLE SUPPLY HOSES
(1, 2)
directly to wall
supplies. Connection on fitting supplies are 3/8
"
compression. Connect left supply hose (Red Stripe) to Hot
wall supply. Connect right supply hose (Blue Stripe) to Cold
wall supply. Use adjustable wrench to tighten connections.
Do not over tighten.
*
Faucet supplies are 21
"
long from faucet base.
•
Note: If additional supply length is required, installer
must purchase additional parts separately.
•
Important: If SUPPLY HOSES (1, 2) are too long,
loop as illustrated to avoid kinking.
MAKE WATER SUPPLY CONNECTIONS
3
CONNECT SPRAY HOSE & INSTALL WEIGHT
4
CHECK CONNECTIONS FOR LEAKS
• Move HANDLE into “off” position.
• Turn on water supplies and check
connections for leaks.
• Operate HANDLE up and down, left
and right to flushwater lines thoroughly.
• Operate HAND SPRAY and
check connections for leaks.
CHECK CONNECTIONS
FOR LEAKS
RED
STRIPE
BLUE
STRIPE
1
2
COLD
HOT
• Push the SPRAY HOSE END
(2)
into the HOSE CONNECTOR
(1)
slide down LOCKING COLLAR
(3)
until it snaps into place
to secure connection.
• With HAND SPRAY
(4)
seated in SPOUT
(5)
, install WEIGHT
(7)
onto HOSE
(6)
21 inches from the underside of the sink deck
and secure with SCREW
(8)
.
• With one weight, spray will retract and dock potentially
requiring slight assistance.
7
6
8
2
1
3
4
5
