M 9 6 8 4 9 1 R e v . 1 . 2
6
10a
TEST INSTALLED FITTING
With HANDLES
(3)
in OFF position, turn on WATER
SUPPLIES
(6)
and check all connections for leaks.
Remove AERATOR
(7)
.
Operate both HANDLES
(3)
to flush water lines thoroughly.
Replace AERATOR
(7)
.
9
6
1
2
3
5
6
4
CHECK DRAIN CONNECTIONS
Operate POP-UP KNOB
(8)
and fill lavatory with water.
Check that DRAIN STOPPER
(9)
makes a good seal
and retains water in SINK. If DRAIN STOPPER
(9)
does not seal properly, please refer to Troubleshooting
section in these instructions.
Release POP-UP KNOB
(8)
down and check all drain
connections and "P" trap for leaks. Tighten
if necessary.
12
WASTE
OUTLET
SERVICE
11
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Pull out INDEX CAP
(1)
and remove HANDLE SCREW
(2)
.
Pull off HANDLE
(3)
and ADAPTER
(4)
.
Remove SPRING CLIP
(5)
.
Lift STOP WASHER
(6)
, turn 90˚ and replace.
Replace SPRING CLIP
(5)
.
Replace ADAPTER
(4)
, HANDLE
(3)
, SCREW
(2)
, and INDEX CAP
(1)
.
AERATOR may accumulate dirt causing distorted and reduced water
flow. Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF to ON position.
Do not force - handles turn only 90˚.
“P” TRAP
7
4
8
90˚
10
Turn VALVE into OFF position.
Push ADAPTER
(1)
into VALVE STEM
(2)
.
Align HANDLE
(3)
and install onto ADAPTER
(1)
.
Install HANDLE SCREW
(4)
and tighten to secure
HANDLE
(3)
.
Insert INDEX BUTTON
(5)
.
INSTALL HANDLES
5
4
3
1
2
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
CARE INSTRUCTIONS: