7275.200
1
M 9 6 8 4 9 0
Drill a one inch dia. hole in mounting surface if required. Mounting holes in ware can range from 1" to 1-3/8" dia.
Remove
mounting nuts, washers, coupling nuts
and
pipe connection
from spout shank if attached.
Assemble
rubber washer
onto
body shank.
Place
body shank
through hole in mounting surface and align fitting. Assemble
steel washer
and
lock nut.
Tighten securely.
Pipe to service to complete installation.
See rough-in drawings for pipe connection
requirements.
After installation is complete turn service on and check all connections
for leaks.
TOOLS AND SUPPLIES REQUIRED
Adjustable Wrench
Teflon Tape
Drill
Plumbers' Putty or
Caulking
INSTALLATION IS TYPICAL FOR ALL
WATER FITTINGS
Channel Locks
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A
COARSE SURFACE.
7275.300
7275.100
INSTALL FITTING [7275.100, 7275.200, 7275.300]
LOCK NUT
STEEL WASHER
FITTING
BASE
BODY
SHANK
RUBBER WASHER
IMPORTANT: FLUSH ALL SUPPLY LINES PRIOR TO FITTING INSTALLATION.
