1
COMBO VALVE TURRET FITTINGS
AND VANDAL RESISTANT
For vandal resistant fitting only, a pin hole will be need to be drilled into the deck offset from the mounting shank hole.
Note:
For vandal resistant models it is important to obtain the rough-in drawing for the particular model. The
drawing illustrates exact size and positioning of the offset hole. Drill a 5/16" [8mm] dia. hole 1/2" [13mm] deep
in mounting surface, per roughing-in dimensions for vandal resistant pin.
Note: 7274.515/525 require inlet shank M962323-0070A for installation
and must be ordered separately.
Apply
putty
to underside of
turret body
to assure a good seal and level fit.
If installing a vandal resistant fitting, align
pin
with
pin hole
in mounting surface.
Place
body shank
through hole in deck and assemble
steel washer
and
lock nut. Tighten
securely.
Pipe to correct service to complete installation.
After installation is complete turn service on and check all connections
for leaks.
TOOLS AND SUPPLIES REQUIRED
Adjustable Wrench
Teflon Tape
Drill
Plumbers' Putty or
Caulking
Product names listed herein are trademarks of American Standard Inc. © A m e r i c a n S t a n d a r d I n c . 2 0 0 4
HOTLINE FOR HELP
For toll-free information and answers to your questions, call:
1 (800) 442-1902
Weekdays
8:00 to 7:00 p.m. Eastern Time
CANADA
1-800-387-0369 (TORONTO 1-905-306-1093)
PUTTY
LOCK NUT
STEEL WASHER
M962323-0070A
3/8" NPT X 4-3/4"
INLET SHANK WITH
LOCKNUT & WASHER
VANDAL RESISTANT PIN
ON VANDAL RESISTANT
FITTINGS ONLY
OFFSET HOLE FOR
VANDAL RESISTANT PIN
TURRET
BODY
Channel Locks
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR
WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH,
ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A
COARSE SURFACE.
M 9 6 8 4 8 6
IMPORTANT: FLUSH ALL SUPPLY LINES PRIOR TO FITTING INSTALLATION.
