American Magnetics 430, Installation, Operation And Maintenance Instructions

Page: 240 / 254

224 R
EV
9
A
MERICAN
M
AGNETICS
, I
NC
. A
PPENDIX
: U
PGRADING THE
M
ODEL
430 F
IRMWARE VIA
F
LASH
C
ARD
R
EADER
6. When prompted with the
Confirm File Replace
dialog, select
Yes To All
.
7. When the extraction process concludes, select
Finish
.
8. Close all open windows for the CF drive.
9. Use the
Safely Remove Hardware
icon in the tool tray to eject (unmount)
the CF card from the host computer.
10.Remove the CF card from the card reader.
11.Re-install the CF card in the Model 430 - ensure the card is seated properly.
12.Re-install the cover on the Model 430 using the previously removed screws.
NOTE
The Model 430 and the host computer must share the same
network address scheme and be attached to the same physical
network in the following process.
13.Verify that the web interface is functioning correctly as follows:
a. Connect the Model 430 to the host computer using one of the
following two methods:
(1.) Via Ethernet cable to the same physical network
as the
host computer
.
(2.) Via “crossover” or “null modem” Ethernet cable directly to
the host computer’s Ethernet port.
b. Plug in and power up the Model 430.
c. As the Model 430 boots up, watch the front display and verify that it
shows
Firmware Version: 1.62
13
(or other version being upgraded
to).
d. Press
<
ENTER
>
at the
Turn on power supply
prompt.
e. Using the Model 430 menu system,
Menu > Net Settings > IP
Address (Present)
, determine the
IP Address
of the Model 430.
13. Display time may vary depending on network speed - refer to section on page 191.