Rev. 5
37
Operation
Shift Key Commands
3.7
SHIFT-key Commands / Menus
The most commonly used commands and menus (other than ramping
controls) are accessed using the
SHIFT
key followed by a numeric keypad
key. Use of the specific SHIFT-key commands and menus is described in
sections specific to the functionality of that specific SHIFT-key. In general,
a SHIFT-key command is executed or SHIFT-key menu is accessed by first
pressing the
SHIFT
key (which turns on the
SHIFT
LED), and then
pressing
1
one of the keys of the numeric keypad (
0
through
9
, “
.
”, or “
+/-
”).
The SHIFT-key command / menu for each key of the numeric keypad is
shown in light blue text at the top of each key. To access the voltage limit
menu, for example, press the
SHIFT
key, and then press the
VOLTAGE
LIMIT
key (also the
2
key). Note that some of the SHIFT-key menus can
also be accessed using the setup menu.
Pressing the
ESC
key or the
SHIFT
key a second time will clear the
SHIFT
function and return the keypad to it's numeric function.
3.7.1
Ramp Rate SHIFT-key
Use of the
RAMP RATE
SHIFT-key provides a menu for setting ramp
rate(s). The ramp rate may be set
2
within the range specified for the
specific Model 430 Programmer configuration (refer to specifications on
page 9). If field units are being used, then the ramp rate setting is
displayed and set in units of kG/sec or T/sec). The allowable range is then
defined by the setting of the coil constant and the allowable range of the
1. Note the SHIFT key and the following keypad key-press are sequential, not simulta-
neous.
2. Using numerical keys per section 3.3 on page 29 or the fine adjust knob (see
Figure 3-5.
SHIFT-Key Functions
Summary of Contents for 05100PS-430-601
