Page 2 of 2
11775 E. 45th Ave. Denver, CO 80239 Ph: 1-800-880-1180 Fax: 303-695-7633
©2021 American Lighting, Inc. REV2143 www.AmericanLighting.com
S SMART
SWITCH
120V
INSTALLATION INSTRUCTIONS
SPKPL-120VSW-WH
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
FCC WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FIGURE 7
FIGURE 11
FIGURE 12
FIGURE 13
FIGURE 14
FIGURE 9
FIGURE 8
FIGURE 10
INSTALLATION CONTINUED:
7. Identify the Neutral wires.Neutral wires are usually WHITE.
- Note: If there is no neutral, try another location or call an electrician for help.
8. Test the Neutral and Ground wires. Ground wires are usually BARE COPPER ,
GREEN, or GREEN & YELLOW. Make sure there is no power on the Neutral wires
from neighboring circuits. If necessary, shut off additional circuits until no votlage
is found.
9. Take photos of the wiring for reference.
10. Loosen the screw terminals and remove the existing switch.
11. Proceed to wire the smart switch. See Figures 11-14 for compatible
configurations. S Smart Switch is not intended to be used on the same
circuit as a traditinoal wall dimmer or smart wall dimmer.
12. Mount the wall switch to the junction box by using the included screws. See
Figure 15.
13. Affix the cover panel by gently pushing on all 4 corners. See Figure 16.
Neutral
8
Neutral
Ground
Traveler
Line /Hot
CONTROLLING THE SMART SWITCH:
The S smart wall switch utilizes Bluetooth Wireless Technology and can be
controlled manually or via the S Smart Lighting App. It is not intended to be used in conjunction with any dimmer.
DISTANCE OF REMOTE CONTROL CAPABILITY:
25 meters (approx. 80ft)
RESET THE DEVICE:
Press and hold the power buttom on the device for 8 seconds until the indicator light begings flashing.
USING THE S SMART LIGHTING APP:
Please follow the S Smart Lighting App guide.
1
2
Cap off the remaining L2 wire (RED) from the
Switch with a wire nut.
Replace ONE of your REGULAR 3-WAY
SWITCHES with SMART SWITCH
Replace BOTH of your REGULAR 3-WAY
SWITCHES with SMART SWITCHES
FIGURE 15
FIGURE 16
