ACCESSORIES IDENTIFIER
(Not to Scale)
©
202 0 Escalad e Sports
Fo r Custome r Servic e Cal l 1-888-996-2729
4
All Rights Reserved.
Assembly Note:
In the following Steps 1 , 2 , & 3 , please exercise patience when starting all H1 & H2
bolts . Be sure to align bolts straight with their respective holes . Be careful not to
cross thread .
Do not push on the bolts while trying to get the bolts to start as you could accidently
push the inner T-Nut out of it fixed position .
A1 - Striker
(2 pcs)
A2 - Puck
(2 pcs)
A3 - Felt Pad
(2 pcs)
NOTE: A3 Felt Pads may already
be attached to A1 Strikers
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation."
"CAUTION: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment."
