Step 11: Take the two long rail/blind assemblies and position by lining up the rail bolt holes in the slate
and the cooresponding threaded rods of the rail. Loosely hand tighten the rails using the domed washer
and nut. (Dome of washer faces down)
Step 12: Slide the end rail/blind assembly onto the table making sure both corners align with the side
rail/blind assemblies. Repeat this step for both ends of the table.
Strep 13: Once all four corners are flush, attach the provided cleats to both the end blind and side blind
as shown below to ensure that all four cornes stay flush during the following steps.
