Rev 10/29/13
9
Setup Menu Functions
Please note that when in the setup menu or in Hand Mode, the door controller reverts to
constant pressure open and close. Also the controller WILL NOT stop when it reaches the
open set point in this mode!!!! Also make sure to start this function when the door is in the
fully closed position and the home sensor is activated (I7.)
When setup mode is entered the door will move slowly in the direction that its commanded to
move. The purpose of this mode is move the door to the desired full open, open deceleration
and close deceleration points and log the numbers so they can be entered the the
corresponding fields.
Please note the following when in setup menu:
•
Press the “Ent” button, then key in the desired set point then press the “Ent again..
•
PLEASE NOTE, AT ANY TIME “F2” CAN BE PRESSED TO GET TO THE MAIN MENU.
•
To get to the next screen, just press the “White” arrow next to the “Next” Icon.
Full Open
– Move the door to the desired full open position then look at
the value of the encoder. Enter that value into this field keeping in
mind that the door will not stop at this value, it will over travel so it’s a
good idea to subtract approximately 100 counts to allow for this.
Open Slow Down
– Move the door to the desired full open position
then look at the value of the encoder. Enter that value into this field.
Press the “Ent” button, then key in the desired set point then press the
“Ent again..
M
*
CK
