Installation Guide
SPEEDDOME ULTRA DRONE II FIXED CAMERA
8000-2682-01, REV D
INSTALLATION GUIDE
1 of 2
SpeedDome
®
Ultra
Drone
™
II Fixed Camera
RAS614 Series
The SpeedDome Ultra Drone II fixed camera is
housed inside a SpeedDome Ultra dome. Two
camera types are available:
NTSC (60Hz color) and
PAL (50Hz color).
Each camera has manually
positioned pan and tilt (the pan has 370° of travel)
and manually set zoom, focus, and iris. The drone
comes fully assembled and is simple to install.
IMPORTANT!
Anytime you are using a VM96 video
controller, and the SpeedDome Ultra Drone II
camera dome is:
•
New:
Reset the VM96 to update the
configuration form to a fixed camera.
•
A replacement for the SpeedDome Ultra
camera dome:
Delete the SpeedDome Ultra
configuration form as explained in the VM96
Administrator’s Manual 8000-0756-05. Then
reset the VM96 to update the configuration
form to a fixed camera.
Procedure
The following steps refer to figures opposite:
1. Attach the camera dome to the base containing
a pigtail connector or an I/O board.
a. Connect the housing and eyeball assembly
to the base by aligning the Cap and Base
tabs.
b. Turn the eyeball assembly clockwise until
you hear a click.
Notes:
This is a fixed camera, no data lines are
required.
If connecting to a pigtail base, an LED at top
of dome housing indicates 12V power. This
LED cannot be seen after connection to the
I/O board.
2. As shown on page 2, turn eyeball if necessary
to access slot cover containing lens. Unsnap
this cover by gently tugging it away from the
eyeball.
3.
You now have access to the camera set screw.
To access lens adjustments, loosen set screw
and gently pull camera out until screw reaches
front end of slot. Retighten set screw.
© 2005 Sensormatic Electronics Corp.
1a
Pigtail Connections (9-pin connector)
Pin
Color
Designation
1–2
N/A
Not used.
3
Black
24Vac
4
Red
Ground
5
White
24vac
6–9
N/A
Not used.
I/O Board Connections (connector P7)
Pin
Color
Designation
1
Black
24Vac
2
Red
Ground
3
White
24vac
Power
LED
1b
Align tabs on
Cap and Base.
Turn clockwise
to latch
