Installation Guide
8000-0975-01, Rev. F
1
1
SensorNet 6-Position
Junction Box (J-Box)
This box provides power and data communications
for up to six SpeedDome or SpeedDome Ultra
camera domes. It also supports up to two outdoor
domes (one per group of ports, P1–3 or P4–6) or a
combination of up to one outdoor dome and three
indoor domes, with the following restriction: if
powering an outdoor dome, no other dome can be
plugged into the same group of connectors (P1–3
or P4–6).
IMPORTANT: Regulatory Requirements
and
other declarations on page 4.
Figure 1. J-Box Components
Installation Requirements
WARNINGS
•
NEVER PIERCE the enclosure.
•
This installation should be made by qualified
service personnel and conform to the National
Electrical Code and applicable local codes.
•
The product shall be located so as to provide
protection against unintentional operation by
employees, janitors and cleaners working
about the premises, by falling objects, by
customers, and by building vibration.
The installation must satisfy the following
requirements:
•
Follow the SensorNet Network Guide section
to ensure proper network design.
•
Minimize exposure to environmental extremes
by mounting the J-Box and the SpeedDome in
a sheltered area when possible.
•
Always use dedicated, unswitched 24-hour AC
power, supplied in accordance with local codes
and with proper grounding.
•
Ensure that the J-Box's power On/Off switch
and fuses are accessible.
•
Always use the four mounting bolts for wall
and pole mount installations.
•
Use the clamp package provided when
banding a camera dome to a pole.
Installation Process
Parts Required
Installation Kit (0351-0739-01) includes:
a) Anchor, toggle and bolt, 1/4x4
4
2880-0040
b) Anchor, wedge, bolt, 1/4x4
4
2880-0052
c) Screw, #10x1-1/24
4
2812-7816
d) Flat washer, wide, type B, #10
4
2848-9306
e) Conn, Plug Tublr, 1 x 4 Posn
6
2109-0254-03
f) Conn, Plug, Tublr 1 x 5 Posn
6
2109-0254-04
g) Grommet, Edge, Continuous
1ft 3100-0029-01
h) Bushing, STR RLF
1
3100-0035-11
A. Fuses
G. Chassis
B. PC board (PCB)
H. TB1 connector
C. Enclosure
I. Knockouts
D. Mounting
Bracket
J. Latch
E. Cover plate
K. TB2 connector
F. On/Off
switch
A
E
F
G
D
C
B
H
I
K
J
