ADTT16E TOUCH TRACKER CONTROLLER WITH INTELLEX
8000-2637-02, REV. C
INSTALLATION INSTRUCTIONS
2 of 6
Parts Required
ADTT16E Touch Tracker Controller
Installation Kit
Part Number 0351-0474-06
Description Qty.
Part
No.
Modular cable assy
4.3m 6003-0047-01
Screw, M2.9x9.5
1
5899-0004-102
Anchor, 4-8x.750
2
2880-0083-01
Screw, #8x1
2
2816-7634-44
Conn, 1x5pos
1
2109-0254-04
Lug, 22-16AWG
3
2141-0002
Cable, 3-cond, 18AWG
5m
6002-0024-01
Interconnect box
1
0300-1000-01
Serial cable, DB9M-DB9F
1
6003-0017-05
Hood, D-Sub, 9pos, cable
1
2125-0007-02
Conn, D-Sub, plug, hsg, 9pos
1
2130-0021-01
Contact, pin, D-Sub, 22-26 AWG 1
2103-0092-01
WARNING:
Shock Hazard!
Disconnect AC Power to the
Switch.
CAUTION:
Static Sensitive Components!
Follow proper handling procedures to
prevent component failure.
Installation Procedure
1. Terminate the external interconnect module
(EIM) at the end of the SensorNet network. See
the diagram on page 3 or 4.
For more information on the SensorNet
network, refer to the SensorNet Network Guide
(PN 8000-0970-01).
2. Mount the EIM on a wall or other surface within
3m (10') of the ADTT16E Touch Tracker.
3. Connect the power transformer and SensorNet
cable to J3 on the EIM.
4. Connect the DB9M-DB9F Serial Cable (PN
6003-0017-05) to the DB9 connectors on the
EIM and Intellex back panel. Refer to the
illustrations on pages 3 or 4 for additional
information.
5. Connect the data cable from J1 on the main
ADTT16E Touch Tracker EIM to the Remote
port at the rear panel of the multiplexer.
6. Connect the modular cable from J2 on EIM to
the ADTT16E Touch Tracker.
7. Connect the SensorNet cable from the dome to
the terminated EIM.
8. Plug the power transformer into a grounded,
3-wire receptacle.
NOTE:
If the keypad and backlighting do not
illuminate when power is applied, unplug each
power transformer and repeat steps 3
through 8.
9. From the ADTT16E Touch Tracker, press
Menu
to configure the software for the Intellex
system.
10. Using the Tracker Ball, page down the screen
to the
Config Devices
menu option.
11. Press the zoom/focus button to select the
Config Devices
menu option.
12. Press
Next
to the select the appropriate device
for this installation. See the example screen
below.
Device = Mux 16
= POSEM
13. Press
Menu
to select the device configuration
and return to the Camera Control mode.
!
