American Dynamics AD2089, Operator'S Manual

Page: 51 / 60

Monitor Arming Commands
43
Appendix E: Monitor Arming Commands
Monitors are armed for alarm call up with codes that specify the following three parameters:
1 The display method ( single , dual , or block monitors).
2 The queuing method ( sequence or hold )
3 The clearance method ( instant , auto , or manual )
To arm a monitor with a AD2089 keyboard:
1 Call the monitor to be armed.
2 Turn the keyswitch to the PROGRAM position.
3 Enter the monitor arming code number (see table)
4 Press the F2 key.
A keyboard operator can also program any monitor armed for instant or auto clearance, for
clearance via manual override. Manual override is enabled or disabled after the arming code is
programmed. If enabled, an “A” will appear after the three-letter acronym for the arming code that
appears on the monitor status line.
When using the AD1024 matrix switcher/controller system, monitors can be armed through S3
system setup software with a PC interface, or through the AD1024 embedded software with the
AD2089 keyboard. Following is a table of monitor arming codes and the commands that enable
the codes.
Monitor Arming Codes Monitor Acronym Command Sequence
Display Arming Status see entries below 300, F2
Single, Sequence, Instant SSI 301, F2
Single, Sequence, Auto SSA 302, F2
Single, Sequence, Manual SSM 303, F2
Single, Hold, Instant SHI 304, F2
Single, Hold, Auto SHA 305, F2
Single, Hold, Manual SHM 306, F2
Block, Sequence, Instant BSI 307, F2
Block, Sequence, Auto BSA 308, F2
Block, Sequence, Manual BSM 309, F2
Block, Hold, Instant BHI 310, F2
Block, Hold, Auto BHA 311, F2
Block, Hold, Manual BHM 312, F2
Dual, Hold, Instant
Dual, Sequence, Instant
DHI/DSI * 313, F2
Dual, Hold, Auto
Dual, Sequence, Auto
DHA/DSA * 314, F2
Dual, Hold, Manual
Dual, Squence, Manual
DHM/DSM * 315, F2
Disarm Monitor 316, F2