INSTALLATION:
To Open Housing:
• To open the housing, release the four tamper-resistance
screws located at the rear of the housing. (using supplied
4 mm allen wrench).
• Slide the outer housing forward until it reaches the fold-
down position (If you want to remove the outer housing
from the mount, rotate the outer housing 90 degrees to the
side).
To Mount the Housing:
• The 1335/1337 mounting hardware is shipped inside the
housing. To open the housing, see above.
• To mount the housing, slide the head of the two 6 mm bolts
(supplied) into the slide rail located on the bottom of the
housing.
• Position the holes in the slide rail to line-up holes in the
mounting surface.
• Secure housing with supplied washers and 6 mm nuts.
Camera Installation:
• Mount lens to camera body.
• Remove adjustable camera slide from housing (2 mm allen
wrench).
• Mount the camera assembly to the slide using 1/4"-20 bolt
and tighten.
• Install the camera into the housing selecting the proper
slide height in order to center the lens in housing window.
• Tighten the camera slide (2 mm allen wrench) to prevent
movement of the camera during operation.
Wiring Installation:
• Route cables through rear of housing using the two com-
pressing cable entries.
• Tighten compression fittings to insure proper weatherproof
condition.
HEATER ASSEMBLY:
Mounting Instructions:
• Wire thermostat to terminal block after removing jumper.
• Mount the heater element into the front channel on the
housing.
• Plug the heater assembly into the terminal block.
• Mount the terminal block to the rear of the housing (use the
screws supplied).
• The terminal block is designed to distribute main power to
camera and heater. CAUTION: Make sure supply voltage
and equipment voltages are compatible.
SUPPLY VOLTAGE:
20 VA- Heater Assembly
15 VA- Camera Assembly
* * * * * * * *
Thermostat
Camera
Main
Ground
Mounting Holes
Heater
HEATER
FRONT VIEW
HOUSING
