Knob Tip:
From this point forward you will be
using a screw and
2 knobs to attach
each piece
together. Make
sure you turn the
knobs together
equally so bolt is
not over-extended
into one of the knobs, causing knob inset to be
pried loose.
Page 3
Attaching Cross Supports
Step 5 -
Determine Length of Cross Supports
The length of the Cross Supports will be 6
inches greater than the the Scroll Rod (N)
length. For example, to configure the 30”
scroll rods (included with floor stand)
adjust the overlapping Cross Support pair
to 36”. (hint: 36” length is acheived by
overlapping all but 3 holes on each end).
Scroll Rod Length
Cross Support Length
SCROLL ROD LENGTH + 6”
Step 6 - Align and connect Cross Supports
Keeping attachment bolts on top, position two Cross Supports (D) until they combine to
the desired length and holes align. Insert Threaded Bolt (H) through aligned holes of
each Cross Support and secure with knob (M) on each side of bolt.
H
H
D
D
Orient
Attachment Bolts
to Top
M
M
M
M
Step 7 - Connect Cross Supports to Legs
With assistance from another person to hold leg
upright. Insert attachment bolt and pin, located at
the ends of each Cross Support into designated holes
on Leg (A). Cap the bolt with the knob (M) on the
outside of the leg. Repeat untill all Cross Supports
are attached.
top hole (bolt)
bottom hole (pin)
M
D
A
N
