©
American DJ Supply
®
- www.americandj.com - Strobe Ball™ Instruction Manual Page 4
©
American DJ Supply
®
- www.americandj.com - Strobe Ball™ Instruction Manual Page 3
Strobe Ball™
Safety Precautions
• 51 Clear Beams
• 20 RPM Motor
• Easy Lamp Replacement
• Air Cooled
• Light Weight, Compact Case Design
• Built-In Mounting Plate
• Bright ZB-45 Strobe Lamp
• Adjustable Flash Rate
Strobe Ball™
Features
• Be sure that the local power outlet match that of the required volt-
age for your unit.
• Do not attempt to remove or break off the ground prong from
the electrical cord. This prong is used to reduce the risk of electrical
shock and fire in case of an internal short.
• Never operate the unit with the top dome cover removed
• Never plug this unit in to a dimmer pack
• Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between this device and a wall.
• To reduce the risk of electrical shock or fire, do not expose this unit
rain or moisture.
• This unit is intended for indoor use only, use of this product outdoors
voids all warranties.
• During long periods of non use, disconnect the unitʼs main power.
• Always mount this unit in safe and stable matter.
• Power-Cord Protection - Power-supply cords should be routed
so that they are not likely to be walked on or pinched by items
placed upon or against them, paying particular attention to cords at
plugs, convenience receptacles, and the point where they exit from
the fixture.
• Cleaning -The fixture should be cleaned only as recommended by
the manufacturer.
• The fixture should be serviced by qualified service personnel when:
A. The power cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance has been exposed to rain or water.
D. The fixture does not appear to operate normally or exhibits a
marked change in performance.
Power Supply:
Before plugging your unit in, be sure the source volt-
age in your area matches the required voltage for your American DJ
®
Strobe Ball.™ The American DJ
®
Strobe Ball
™
is available in a 120v
and 220v version. Because line voltage may vary from venue to venue,
be sure to plug your fixture into a wall outlet with a matching power
supply before attempting to operate.
Strobe Ball™
Power Supply
Strobe Ball™
Operation
General Operation:
Simplicity! Just plug this fixture in, and watch
it go. This fixture is designed to operate as a stand alone unit, there
is no need of a controller. It has been tested and the lamp has been
installed at the factory there is no assembly necessary. The Strobe
Ball™ is ready to be plugged in, out of the box. There is no power
switch, after plugging the unit in the unit will begin to flash and slowly
rotate. Use the flash adjustment pot on the side of the unit to achieve
your desired flash rate. If there is no lamp output check the breaker
and bulb. If the bulb is good and the breaker has not popped, please
contact our toll free customer support number for further instructions.
Please do not return the unit to your dealer without first contacting
customer support.
Strobe Ball™
Warranty Registration
The Strobe Ball™ carries a one year (365 days) limited warranty. We
recommend you fill out the enclosed warranty card to validate your
purchase. All returned service items whether under warranty or not,
must be freight pre-paid and accompany a return authorization (R.A.)
number. If the unit is under warranty, you must provide a copy of your
proof of purchase invoice. Please contact American DJ
®
customer
support for a R.A. number.
Please carefully read and understand the instructions in this manual
thoroughly before attempting to operate this unit. These instructions
contain important safety information regarding the use and mainte-
nance of this unit. Please keep this manual with the unit, for future
reference.
Strobe Ball™
General Instructions
