Stage Setter 8™ Controls and Functions
Stage Setter 8™ Controls and Functions
Rear Panel - Controls and Functions
17. DC Power Input:
This jack is used to connect to external power supply. Only use the
included DC 12~20V, 500 mA minimum power supply. If it becomes nec-
essary to replace the original power supply, only use an approved American
DJ power supply.
18. Power Switch:
This switch is used to turn the unit’s main power On/Off.
19. DMX Polarity Select:
This switch is used to change the unit’s DMX pin polarity. Polarity can be
changed from pin 2 hot to pin 3 hot and vice versa. The ability to change
the units DMX polarity was incorporated to accommodate older DMX
packs that may follow a pin 2 hot standard.
20. DMX Out:
This XLR jack is used to send DMX data to your DMX dimmer packs or
other DMX fixtures.
23
22
21
20
19
18
17
Rear Panel Label
Rear Panel
©
American DJ Supply
®
- www.americandj.com - Stage Setter 8™ Instruction Manual Page 14
©
American DJ Supply
®
- www.americandj.com - Stage Setter 8™ Instruction Manual Page 13
Rear Panel - Controls and Functions (Cont.)
21. MIDI Thru:
This jack is used to parallel an incoming MIDI signal through to another
MIDI device.
22. MIDI In:
This jack receives an incoming MIDI signal from external MIDI controller
or keyboard.
23. Fog Machine Connector:
Use this connection to connect a compatible American DJ fog machine,
such as the Master Blaster 700 and 1000, Vaporizer, and the Dyno Fog.
This eliminate the need of separate controller.