©
American DJ
®
- www.americandj.com - Roto Balls Tri LED™ Instruction Manual Page 4
©
American DJ
®
- www.americandj.com - Roto Balls Tri LED™ Instruction Manual Page 3
Roto Balls Tri LED™
Operation
Power Supply:
Before plugging your unit in, be sure the source
voltage in your area matches the required voltage for your
American DJ® Roto Balls Tri LED™. The American DJ® Roto
Balls Tri LED™ is available in a 120v and 220v version. Because
line voltage may vary from venue to venue, be sure to plug your
fixture into a wall outlet with a matching power supply before
attempting to operate.
General Operation:
Just plug this light in, and watch it go. This
fixture is designed to operate as a sound active stand alone
unit. The Roto Balls Tri LED™ is ready to be plugged in, out of
the box. There is no power switch, after plugging the unit in the
base and two outer heads will immediately begin to spin.
Adjustable Speed Knob:
The speed at which this unit spins
can be adjusted by turning the knob located at the base of the
unit. When the knob is turned all the way counter-clockwise it
will spin the slowest at 0 r.p.m. By turning the knob clockwise
you can increase the rate of speed 0 r.p.m. to the fastest rate at
30 r.p.m.
Please carefully read and understand the instructions in this
manual thoroughly before attempting to operate this unit. These
instructions contain important safety information regarding the
use and maintenance of this unit. Please keep this manual with
the unit, for future reference.
Roto Balls Tri LED™
General Instructions
Roto Balls Tri LED™
Precautions
Roto Balls Tri LED™
Unpacking
• Be sure that the local power outlet match that of the required volt-
age for your unit.
• Do not attempt to remove or break off the ground prong from the
electrical cord. This prong is used to reduce the risk of electrical
shock and fire in case of an internal short.
• Do not remove the unit cover under any conditions. There are no
user serviceable parts inside.
• Never plug this unit in to a dimmer pack
• Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between this device and a wall.
• To reduce the risk of electrical shock or fire, do not expose this unit
rain or moisture.
• This unit is intended for indoor use only, use of this product out-
doors voids all warranties.
• During long periods of non use, disconnect the unit’s main power.
• Always mount this unit in safe and stable matter.
• Power-Cord Protection - Power-supply cords should be routed so
that they are not likely to be walked on or pinched by items placed
upon or against them, paying particular attention to cords at plugs,
convenience receptacles, and the point where they exit from the fix-
ture.
• Cleaning -The fixture should be cleaned only as recommended by
the manufacturer.
• The fixture should be serviced by qualified service personnel when:
A. The power cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance has been exposed to rain or water.
D. The fixture does not appear to operate normally or exhibits a
marked change in performance.
To optimize the performance of this product, please read these
operating instructions carefully to familiarize yourself with the basic
operations of this unit. These instructions contain important safety
information regarding the use and maintenance of this unit. Please
keep this manual with the unit, for future reference.
