©
American DJ
®
- www.americandj.com - Quick Scan™ Instruction Manual Page 9
©
American DJ
®
- www.americandj.com - Quick Scan™ Instruction Manual Page 10
Quick Scan™ Fuse & Lamp Replacement
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
®
service
technician. Replacing with anything other than the specified part can
damage your unit and will void your manufactures warranty.
Warning:
If you continue to blow either the lamp or fuse, one after
another, STOP using the unit. Contact customer support for further
instructions, you may have to return the unit for servicing. Continuing
to use the unit may cause serious damage.
Lamp Replacement:
Caution! Never open the unit when it is in
use. Always disconnect the main power and allow the fixture ample
time to cool before attempting to replace the lamps. Again, please
remember to always replace with the exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
lamps. Never touch the new lamp with your bare fingers.
2. Unscrew the two thumb screws on the back of the unit.
3. Once the thumb screws have been removed, remove the lamp
assembly cover to expose the lamp.
4. Remove and replace the lamp
5. Reassemble in reverse order.
Fuse Replacement:
Disconnect from the main power supply. Insert a
standard flat head screw driver in to the fuse holder housing, located
on the back of the unit. Turn the screwdriver in counter-clockwise
direction to remove the fuse holder. Remove the old fuse and discard
it, replace the fuse with the same type. Insert the fuse back into it’s
housing.
For any other service related issues, please contact American DJ
®
customer support.
Halogen Lamp Warning:
This fixture is fitted
with halogen lamps which are highly susceptible
to damage if improperly handled. Never touch the
lamps with your bare fingers as the oil from your
hands will shorten lamp life. Also, never move the
fixture until the lamps have had ample time to cool.
Remember, lamps are not covered under warranty
conditions.
Quick Scan™
Set Up and Operation
Follow the dip switch setting below to obtain a completely sound active
synchronized light show. Head movements will match step for step.
Master/Slave/Sound Active Mode:
The Quick Scan System runs
in a master/slave sound active mode, only. In this mode the system
runs to the beat of the music without any type of controller. The slave
units will follow the master heads movement step for step. Before
plugging your units in, be sure the dip switches are set to the proper
Master/Slave Setting. The dip switches are located on the back of the
units.
1. Mount your units in a safe and secure manner.
2. Connect the “slave” units to the “master” unit. Using the provided
XLR microphone cables, daisy chain your units together via
the XLR connector on the rear of the units. Remember the Male
XLR connector is the input and the Female XLR connector is the
output.
3. Follow the dip switch settings on this page. The dip switches are
located on the back near the bottom of the unit.
4. If you wish to use the optional remote control, connect it now. The
remote control will allow you to activate a blackout mode.
5. Connect the unit to main power.
6. The unit will now react to the low frequencies of music via the
internal microphone.
MASTER
SLAVE 1
SLAVE 2
SLAVE 3
1
1
1
1 2 3
5
4
7
9 10
8
6
ON
2 3
5
4
7
9 10
8
6
ON
2 3
5
4
7
9 10
8
6
ON
2 3
5
4
7
9 10
8
6
ON
