©
American DJ Supply
®
- www.americandj.com - Fusion FX Bar 3 Instruction Manual Page 14
©
American DJ Supply
®
- www.americandj.com - Fusion FX Bar 3 Instruction Manual Page 13
Fusion FX Bar 3 Cleaning
Due to fog residue, smoke, and dust cleaning the internal and exter-
nal optical lenses must be carried out periodically to optimize light
output.
1. Use a soft cloth to wipe down the outside casing.
Cleaning frequency depends on the environment in which the fixture
operates (i.e. smoke, fog residue, dust, dew).
Listed below are a few common problems the user may encounter,
with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are
wired correctly (pin 3 is “hot”; on some other DMX devices
pin 2 may be ‘hot’). Also, check that all cables are connected
to the right connectors; it does matter which way the inputs
and outputs are connected.
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
If problems are not resolved;
Contact American DJ® for service.
1-800-322-6337
Fusion FX Bar 3 Trouble Shooting
First unplug the power. The fuse holder is located next to the power
inlets. Using a flat-head screw driver unscrew the fuse holder. Remove
the bad fuse and replace with a new one.
Fusion FX Bar 3 Fuse Replacement
Fusion FX Bar 3 UC3 Control
Fusion FX Bar 3 DMX Channels & Functions
Channel Value
Function
1 DIMMER/STROBE
0 - 7 OFF
8 - 190 MASTER DIMMER 0% - 100%
191 - 200 SOUND ACTIVE
201 - 247 STROBING SLOW - FAST
248 - 255 FULL ON
2 0 - 255 SPOT 1
3 0 - 255 SQUARE 1
4 0 - 255 SPOT 2
5 0 - 255 SQUARE 2
6 0 - 255 SPOT 3
7 0 - 255 SQUARE 3
8 0 - 255 SPOT 4
Sound Active: Set Channel 1 between the values of 191 - 200.
Channels 2-8 must be set between the same values for those
channels to run sound active.
Stand By
Blackout the unit
Function
1. White LED Strobe
2. Spot LED strobe
Select show
Show1-19
Mode
Sound (LED OFF)
LED ON
