©
American DJ
®
- www.americandj.com - Flash Duo™ Instruction Manual Page 8
3. Be sure the lamp is good.
4. If the lamps was recently replaced, be sure the lamp probes
are properly inserted in the socket assemble.
Unit does not rotate and lamp does not turn on;
1. Be sure you have connected your unit into a matching wall
outlet.
2. Be sure the external breaker does not have to be reset. The
breaker is located on the lower section of the unit.
3. Be sure the power cord is properly seated in the power out
let.
4. Be sure your main power outlet has power.
Flash Duo™
Trouble Shooting cont.
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning the fixture should
be carried out periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the
outside casing every 20 days.
2. Use a small brush and normal glass cleaner with a soft cloth
to wipe down the inside casing and clean out the cooling
vents every 30-60 days.
3. Always be sure to dry all parts completely before plugging
the unit back in.
4. Frequent cleaning will extend lamp life and ensure fixture reli-
ability.
Cleaning frequency depends on the environment in which the
fixture operates (I.e. smoke, fog residue, dust, dew). In heavy
use we recommend cleaning on a monthly basis. Periodic
cleaning will ensure longevity, and crisp beam output.
Listed below are a few common problems and solutions you
should try before contacting customer support.
Unit rotates but has no light output from the unit;
1. Be sure you have connected your unit into a matching wall
outlet.
2. Remove the lamp cover and be sure the lamp is seated in its
socket properly. Occasionally lamps become loose during
shipping. Make sure the lamp is in its socket all the way.
Flash Duo™
Trouble Shooting
Flash Duo™
Cleaning
©
American DJ
®
- www.americandj.com - Flash Duo™ Instruction Manual Page 7
Flash Duo™
Breaker Reset
This unit is equipped with a safety breaker. This breaker is
designed to close the power circuit in the event of an internal
short, reducing the risk of electric shock and fire. To reset the
breaker, push the breaker button in until you hear it pop back
in to place. If the breaker continues to pop, stop using the unit
and contact customer support the unit may require service.
