American DJ
®
USER INSTRUCTIONS
FLASH 2C
-
Flash Tube Controller
© AMERICAN DJ® LOS ANGELES, CA 90058
Specifications:
Model - Flash 2C
Maximum load
: 15 amps or 1800 watts per relay pack (using
separate circuit for each).
Size:
SC-8FC
- 19” x 2” x 2”
SC-RP8
- 19” x 5” x 2”
System weight:
13lbs.
15
17
16
CONNECTIONS AND FUNCTIONS:
15. FLASH TUBE CONTROLLER SOCKETS -
Connect your flash tubes to these sockets.
16. BREAKER -
This unit is equipped with a built-in 30 Amp safety breaker. This breaker is designed
to close the power circuit in the event of an internal short or power surge. This will reduce the risk of
electrical shock or fire and protect the circuitry. To reset the breaker, push the breaker button in until
you hear it “pop” back in to place. If the breaker continues to pop, stop using the unit and contact
our customer support team, the unit may need to be returned for service.
17.
POWER CORD -
This cord is used to supply main power to the fixture. Be sure the main power
matches the required power of your fixture. The rated power requirements are clearly marked on the
rear panel of the unit.
OPERATING INSTRUCTIONS:
1. Attach your flash tubes to the Flash Tube Sockets located on the back of the controller.
Note: After every flash tube, connect a booster, and at the end of the flash tube line, you
need to conncet a terminator.
2. Now plug the controller into matching power outlet.
3. Follow the functions on the front page to control the speed, rate, and patterns you desire.
