Festive Light Pak™
Color Ball™ Operation
COLOR BALL
Power Supply:
Before plugging your unit in, be
sure the source voltage in your area matches the
required voltage for your American DJ
®
Color Ball™
before attempting operation. See the next page for
lamp relplacement and breaker reset
General Operation:
Just plug this light in, and
watch it go. This fixture is designed to operate as a
stand alone unit. It has been tested and the lamp has
been installed at the factory, there is no assembly
necessary. The Color Ball™ is ready to be plugged
in, out of the box, there is no power switch. If there is no lamp output
check the fuse and bulb. If the fuse and bulb are good, please return
the unit for servicing.
Color Ball™
Lamp Installation/Replacement
Caution:
Always replace with the exact same type lamp, unless oth-
erwise specified by an authorized American DJ
®
technician. Replace
with anything other than the specified part can damage your unit and
will void your manufactures warranty.
Warning:
If, after replacing; the lamp continues to blow, STOP using
the unit. Contact customer support for further instructions, you may
have to return the unit for servicing. Continuing to use the unit may
cause serious damage.
Breaker Reset:
This unit is equipped with a built-in safety breaker.
This breaker is designed to close the power circuit in the event of an
internal short or power surge. This will reduce the risk of electrical
shock or fire and protect the circuitry. To reset the breaker, push the
breaker button in until you hear it “pop” back in to place. If the break-
er continues to pop, stop using the unit and contact our customer
support team, the unit may need to be returned for service.
Lamp Installation/Replacement:
Caution! Never attempt to
change the lamp while the fixture is plugged in. Always disconnect
the main power and allow the unit ample time to cool before attempt-
ing to replace the lamp.
1. Be sure to follow the proper handling procedures that deal
with halogen lamps.
2. Remove the three thumb screws that secure the upper half of the
lens dome to the lower half.
3. Carefully remove the upper half of the dome by pulling it straight
up to access the lamp socket assembly.
4. Carefully remove the old lamp and discard it in the trash.
5. Replace the lamp with an exact match and reassemble.
Halogen Lamp Warning:
This fixture is fitted
with a halogen lamp which is highly susceptible
to damage if improperly handled. Never touch the
lamp with your bare fingers as the oil from your
hands will shorten lamp life. Also, never move the
fixture until the lamp has had ample time to cool.
Remember, lamps are not covered under warranty
conditions.
©
American DJ
®
- www.americandj.com - Festive Light Pak™ Instruction Manual Page 8
©
American DJ
®
- www.americandj.com - Festive Light Pak™ Instruction Manual Page 7
