©
American DJ
®
- www.americandj.com - Fascinator™ Instruction Manual Page 6
©
American DJ
®
- www.americandj.com - Fascinator™ Instruction Manual Page 5
Fascinator™
Controls and Functions
REAR
1.
Cooling Fan -
Keep the fan grill clean. Never block the fan vents,
always allow at least four inches between the fan and any other
surface. Improper cooling may result in premature lamp failure.
2.
MINI/C Controller Jack
- This is for use the optional MINI/C Black
out controller only.
Do not attempt to connect an audio signal
this jack, this will damage the PC board and void your manu-
factures warranty!
3.
XLR Input Jack -
This jack is used to accept an incoming DMX
signal or Master/Slave signal.
4.
Dip Switches -
These switches serve two functions. In master
slave mode these switches are used to assign a specifi c head
address. In DMX mode these switches are used to assign a
DMX address to the unit. In DMX mode each switch corresponds
to a specifi c value based on binary code. See page 7 for a detailed
explanation of DMX binary code.
5.
XLR Output Jack -
This jack is used to transmit the incoming
DMX signal to another DMX fi xture, or transmit a Master/Slave
Fascinator™
Controls
and
Functions
1
2
3
4
5
6
7
8
9
ON
2
8
9
5
4
3
1
6 7
signal to the nest Fascinator™ in the chain. For best results in DMX
or Master/Slave mode terminate this jack if it is the last unit in the
chain. See
“Terminator”
on page 7.
6.
Audio Sensitivity Knob -
This adjust audio sensitivity of the
internal microphone (3). Turning the sensitivity knob in the clock-
wise direction will increase the sensitivity to sound. Turning the
knob in the counter clockwise direction will decrease the fi xture’s
sensitivity to sound.
7.
Microphone -
This microphone receives external low frequencies
to trigger the unit in Sound-Active and Master/Slave mode.
8.
Fuse Holder -
This housing stores the 5 amp GMA protective
fuse. Always replace with the exact same type fuse, unless other
wise instructed, by an authorized American DJ
®
service technician.
9.
Power Cord -
Connect only to a matching power outlet. Never use
this fi xture is the ground prong has been removed or broken off.
