![background image](http://html1.mh-extra.com/html/american-dj/essential-light-pak/essential-light-pak_user-instructions_2923075005.webp)
Essential Light Pak™
Beamer™ Operation
BEAMER
Power Supply:
Before plugging your unit in, be
sure the source voltage in your area matches the
required voltage for your American DJ
®
Beamer™
before attempting operation. See the next page
for lamp relplacement and breaker reset
General Operation:
Just plug this light in, and
watch it go. This fixture is designed to operate
as a stand alone unit. It has been tested and the
lamp has been installed at the factory, there is no
assembly necessary. The Beamer™ is ready to be plugged in, out of
the box, there is no power switch. If there is no lamp output check
the fuse and bulb. If the fuse and bulb are good, please return the
unit for servicing.
Unit will react to bass sound of music via the internal microphone.
Adjust the sensitivity knob on the unit to music sensitivity. Be sure not
to obstruct cooling vents and keep in a well ventilated area. Fog best
results, fog or special effects smoke must be used in order to see the
beams of light.
Please note that tapping on the unit, or high pitched sounds may not
trigger the unit, the unit is designed to react to low frequencies (bass).
Also note that the music sensitivity is preset at the factory and may
not be changed or adjusted.
Beamer™
Fuse & Lamp Replacement
Caution:
Always replace with the exact same type lamp, unless oth-
erwise specified by an authorized American DJ
®
technician. Replace
with anything other than the specified part can damage your unit and
will void your manufactures warranty.
Warning:
If, after replacing; the lamp continues to blow, STOP using
the unit. Contact customer support for further instructions, you may
have to return the unit for servicing. Continuing to use the unit may
cause serious damage.
Breaker Reset:
This unit is equipped with a built-in safety breaker.
This breaker is designed to close the power circuit in the event of an
internal short or power surge. This will reduce the risk of electrical
shock or fire and protect the circuitry. To reset the breaker, push the
breaker button in until you hear it “pop” back in to place. If the break-
er continues to pop, stop using the unit and contact our customer
support team, the unit may need to be returned for service.
Lamp Replacement:
Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power
and allow the unit ample time to cool before attempting to replace
the lamp.
1. Be sure to follow the proper handling procedures that deal with
halogen lamps.
2. Remove the thumb screw on the top of the unit that holds the
front cover in place.
3. After removing the thumb screw, pull down the front cover the
of the unit to expose the lamp.
4. Carefully remove the old lamp and discard it in the trash.
5. Replace the lamp with an exact match and reassemble in reverse
order.
Halogen Lamp Warning:
This fixture is fitted
with a halogen lamp which is highly susceptible
to damage if improperly handled. Never touch the
lamp with your bare fingers as the oil from your
hands will shorten lamp life. Also, never move the
fixture until the lamp has had ample time to cool.
Remember, lamps are not covered under warranty
conditions.
©
American DJ
®
- www.americandj.com - Essential Light Pak™ Instruction Manual Page 10
©
American DJ
®
- www.americandj.com - Essential Light Pak™ Instruction Manual Page 9