![background image](http://html1.mh-extra.com/html/american-dj/electra-ii/electra-ii_user-instruction_2923066003.webp)
©
American DJ Supply
®
- www.americandj.com - Electra II™ Instruction Manual Page 6
©
American DJ Supply
®
- www.americandj.com - Electra II™ Instruction Manual Page 5
Trouble Shooting:
Listed below are a few common problems that
you may encounter, with solutions.
No light output from the unit;
1. Be sure you have connected your unit into a standard
110V wall outlet.
2. Be sure the external fuse has not blown. The fuse is
located on the rear panel.
3. Remove the lamp cover and be sure the lamp is seated
in its socket properly. Occasionally lamps become loose
during shipping be sure the lamp is push in to its socket
all the way.
Unit does not respond to sound;
1. Be sure the unit's mode switch is in the "I" position, this is
the only mode that allows the unit to operate in sound
active mode.
2. Low frequencies (bass) should cause the unit to react to
sound. Tapping on the microphone, quiet or high
pitched sounds may not activate the unit.
Electra II™
Halogen Lamp Warning
Electra II™
Lamp Replacement
Caution:
Always replace with the exact same type lamp, unless oth-
erwise specified by an authorized American DJ
®
technician. Replace
with anything other than the specified part can damage your unit and
will void your manufactures warranty.
Warning:
If after you have replaced the lamp and you continue
to blow lamps, STOP using the unit. Contact customer support for
further instructions, you may have to return the unit for servicing.
Continuing to use the unit may cause serious damage.
Lamp Replacement:
Disconnect from the main power supply. Be
sure the unit has had ample time to cool before attempting to replace
the lamp. On the front of the unit there is a single thumb screw. Remove
the thumb screw and pull back the front case housing. The housing is
hinged which allows it to pull back without being removed. Remove
the old lamp from the socket assembly. Carefully install the new lamp,
be sure to follow all the installation guide lines that are included with
your new lamp. Close the front cover and replace the thumb screw.
Remove the thumb screw on the front of the unit as illustrated below.
Remove the lamp from the socket and insert a new one as illustrated above.
This fixture is fitted with halogen lamps which are
highly susceptible to damage if improperly handled.
Never touch lamp with your bare fingers as the oil
from your hands will shorten lamp life. Also, never
move the fixture until the lamps have had ample
time to cool. Remember, lamps are not covered
under warranty conditions.
Electra II™
Trouble Shooting
Electra II™
Warranty Registration
The Electra II™ carries a one year (365 days) limited warranty. We
recommend you fill out the enclosed warranty card to validate your
purchase. All returned service items whether under warranty or not,
must be freight pre-paid and accompany a return authorization (R.A.)
number. If the unit is under warranty, you must provide a copy of your
proof of purchase invoice. Please contact American DJ
®
customer
support for a R.A. number.