ADJ Products, LLC - www.adj.com - Eco UV Bar DMX User Manual Page 9
ADJ Products, LLC - www.adj.com - Eco UV Bar DMX User Manual Page 8
Eco UV Bar DMX
DMX Control
Universal DMX Control:
This function allows you to use a Elation®
universal DMX-512 controller to control the chases and patterns, dim-
mer and strobe. A DMX controller allows you to create unique pro-
grams tailored to your individual needs. The Eco UV Bar DMX has 3
DMX Channels.
1. This function will allow you to control each individual fixture’s
traits with a standard DMX 512 controller such as the
Elation® Show Designer™ or the Elation® DMX Operator.
2. To run your fixture in DMX mode, set your desired DMX address
following the directions on page 7, and the set-up specifications
that come with your DMX controller.
3. Plug in the fixture via the XLR connections to any standard DMX
controller.
4. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
Eco UV Bar DMX Operating Instructions
2. The output intensity can be adjusted between 000 (off) to 255 (bright-
est).
3. Use the UP and DOWN buttons to adjust the output intensity to your
desire.
Note: The delay mode works in conjunction with Channel 3 values 101-
255.
Master-Slave Operation:
This function will allow you to link up to 16
units together and operate without a controller. The units will be sound
activated. In Master-Slave operation one unit will act as the controlling
unit and the others will react to the controlling units programs. Any unit
can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. On the Master unit set your desired settings.
3. Set the Slave units to DMX mode setting. The Slave units should
now follow the Master.
Eco UV Bar DMX
Cleaning
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 10 fixtures maximum. After 10 fixtures you will need
to use a new power outlet. They must be the same fixtures. DO
NOT mix fixtures.
Eco UV Bar DMX
Power Cord Daisy Chain
Channel Value
Function
1 DIMMER
0 - 255 0% - 100%
2 STROBING
0 - 255 SLOW - FAST
3 DIMMER CURVE
0 - 20 NO DIMMER CURVE
21 - 40 DIMMER CURVE 1
41 - 60 DIMMER CURVE 2
61 - 80 DIMMER CURVE 3
81 - 100 DIMMER CURVE 4
101 - 255 DELAY MODE CONTROL
Eco UV Bar DMX
3 DMX Channels
Eco UV Bar DMX
IR Remote
IR Remote:
The included IR remote is a basic remote control that can
control strobing and strobing speed. Each press of the Strobing but-
ton will change the speed. The strobing speed goes from full on, to
slowest strobing, then moderate strobing and finally fastest strobe.
Pressing the On/Off button will allow the remote to control the Eco UV
Bar DMX.
Channel 3 values 101-255 works in conjuction with Delay mode in the menu setting.
