Operating Modes:
You can use the Concept 1
TM
in three ways:
• Stand alone mode - The unit will react to sound, chasing
through the several built in programs. You can also use the
optional Concept-C Controller to manually control blackout,
strobe, pan, tilt, gobo, color, and scan mode.
• Master/Slave mode - You can daisy chain up to 16 units
together to get a synchronized light show that will react to
sound chasing through several built in programs.
• DMX control mode - This function will allow you to control
each individual fixtures traits with a standard DMX 512
controller such as the American DJ Show Designer.
TM
Stand Alone Mode:
The Concept 1
TM
has a sophisticated built-in light show that will run to
sound when there is no DMX signal present. Plug the fixture in and
it will chase through its programs via sound. You can also use the
optional controller to operate blackout, strobe, or slow scan the units.
Master-Slave Operation:
This function will allow you to link up to 16 units together to run in a
Master-Slave mode. In Master-Slave operation one unit will act as the
controlling unit and the others will react to the controlling units built-in
programs. Any unit can act as a Master or as a Slave however, a unit
must be programmed to act as “Master.”
Master-Slave Connections:
1. Daisy chain your units via the XLR connector on the top of
the unit. Use standard XLR microphone cables to link your
units together. Remember that the Male XLR connector is the
input and the Female XLR connector is the output. The first
unit in the chain (master) will use the female XLR connector
only. The last unit in the chain will use the male XLR
connector only.
Setting Units as Masters or Slaves:
This section will detail the procedure for switching units between
Masters and Slaves. Each unit can function as a “Master” or as a
“Slave” To adjust the settings:
1. Be sure the main power switch is set to the “OFF” position.
2. With the power off press and hold down the LCD “1-Key,”
and turn the power on.
3. Hold the right LCD button down until the LCD reads “
Aud
.”
4. Connect the “Slave” unit or units and they will automatically start to
follow the “Master.”
5. To toggle between Master and Slave mode repeat steps 1-3.
Adjusting The DMX address:
The DMX address is adjusteded by using the “1, 10, and 100” keys
directly below the LCD. Each press of a button will increase the
selected value of one. Please note that each tap of the keys will only
increase the displayed value, you may decrease the value.
Reverse Pan:
1. Be sure the main power switch is set to the “OFF” position.
2. With the power off, press and hold the middle LCD button
“10-key,” and turn the power on.
3. Hold the middle LCD button down until the LCD reads
“
r-p
.”
4. To deactivate this function, repeat the same steps.
Reverse Tilt:
1. Be sure the main power switch is set to the “OFF” postion.
2. With the power off, press and hold the left LCD button “100-key,”
and turn the power on.
Concept 1™ Operating Instructions
Concept 1™ Operating Instructions
©
American DJ Supply
®
- www.americandj.co m - Concept 1™ Instruction Manual Page 10
©
American DJ Supply
®
- www.americandj.com - Concept 1™ Instruction Manual Page 9
100
1
10
Concept 1™ LCD
