©
American DJ
®
- www.americandj.com - Color Flash 4™ Instruction Manual Page 7
©
American DJ
®
- www.americandj.com - Color Flash 4™ Instruction Manual Page 8
Color Flash 4™
Operation
Linking System:
Your Color Flash 4™ system comes with built-in
programs for a four unit system. Follow the step above for proper
linking and set-up procedures. If the system is not set up completely,
blank spots will appear in the programs.
Sound Active Operation:
This function allows a system to run to
the beat of the music without any type of controller.
1. Mount your units in a safe and secure manner.
2. Connect the “slave” units to the “master” unit as detailed in the
illustration below.
3. If you wish to use the optional remote control, connect it now. The
remote control will allow you to activate a blackout mode.
4. Connect the unit to main power.
5. The unit will now react to the low frequencies of music via the
internal microphone.
Color Flash 4™
Lamp Replacement
Caution:
Always replace with the exact same type lamps, unless
otherwise specified by an authorized American DJ
®
service techni-
cian. Replacing with anything other than the specified part can dam-
age your unit and will void your manufactures warranty.
Warning:
If you continue to blow lamps one after another, STOP
using the unit. Contact customer support for further instructions, you
may have to return the unit for servicing. Continuing to use the unit
may cause serious damage.
Lamp Replacement:
Caution! Never open the unit when it is in
use. Always disconnect the main power and allow the fixture ample
time to cool before attempting to replace the lamps. Again, please
remember to always replace with the exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
lamps. Never touch the new lamp with your bare fingers.
2. Unscrew the three thumb screws that secure the colored dome
cover to the unit chassis.
3. Once the thumb screws have been removed, remove the dome
assembly to expose the lamps.
4. Remove and replace the lamp that needs replacing with an exact
match. The strobe lamp (ZB-50) has three pins and the other
lamp has two pins. Be sure to replace the correct lamp.
5. Reassemble in reverse order.
For any other service related issues, please contact American DJ
®
For any other service related issues, please contact American DJ
For any other service related issues, please contact American DJ
customer support.
Slave 1
Slave 3
Slave 2
Master
Optional MINI/C Remote Control
Halogen Lamp Warning:
This fi xture is fi tted
with halogen lamps which are highly susceptible
to damage if improperly handled. Never touch the
lamps with your bare fi ngers as the oil from your
hands will shorten lamp life. Also, never move the
fi xture until the lamps have had ample time to cool.
Remember, lamps are not covered under warranty
conditions.
Color Flash 4™
Halogen Lamp Warning
