Bubble Blast™
Operation
©
American DJ Supply
®
- www.americandj.com - Bubble Blast™ Instruction Manual Page 5
©
American DJ Supply
®
- www.americandj.com - Bubble Blast™ Instruction Manual Page 6
Filling the Tray Reservoir:
1. Place the Bubble Blast™ on a fl at level surface.
2. Fill the top tray, using premium American DJ
®
brand bubble juice.
Be sure not to over fi ll the tray to avoid spilling.
Operation:
Once the tray has been fi lled. You may place the unit on fl at level
surface. The power switch on the right will activate the unit, while the
power switch on the left will activate the optional remote control. Flip
the right power switch to the “ON” position and watch the bubbles
come out by the hundreds. Be sure the unit remains in a level position
to avoid accidental leaking.
Remote Operation (Optional):
The unit may be used with an
optional
timer remote that can be used
to control an output interval and duration. Always be sure to connect
the remote to the jack on the rear of the unit prior to applying main
power.
Remote Operation:
1. Plug the timer remote control into the unit.
2. Flip the main power switch on the unit to the “ON” position.
3. Push the power button on the remote to the “ON” position, main
power will be indicated by a glowing red LED above the remote
power button.
4. For a constant steady stream of bubbles press the “CONS-
STANT” button. An amber LED will glow indicating the unit is
in constant output mode. Or press the “TIMER” button for timer
operation. A green LED will glow indicating the unit is in timer
mode.
5. For timer mode operation see the next section.
Bubble Blast™
Optional Timer Remote
Inteval Knob -
This knob is
used the control the time inter-
val between blast when the
unit is in “TIMER” mode. The
time interval can be adjusted
to range from 5 seconds to 10
seconds. Turning the knob in a
clockwise direction will increase
the interval.
Duration Knob -
This knob
is used the control the blast
duration when the unit is in
“TIMER” mode. The blast
duration can range from 1 sec-
onds to 10 seconds. Turning
the knob in clockwise direction
will increase the duration.
Power Button -
When the
remote is connected to the
unit, this button will control
the unit’s main power. When
the unit is powered, a red
LED above the this button
will glow.
Constant Button -
This
button is used to activate
constant mode. When this
mode is activated the unit will
continually produce bubbles
until the unit is turned off or
the reservoir is emptied.
Timer Button -
This button
activates timer mode. When
this mode is activated a green
LED above the this button
will glow. Use the “TIME” and
“DURATION” knobs to adjust
the timer settings.
�
� �
