To next fixture or terminate
From DMX Controller
ON
1 2 3 4 5 6 7 8 9 10
ON
1 2 3 4 5 6 7 8 9 10
ON
1 2 3 4 5 6 7 8 9 10
©
American DJ Supply
®
- www.americandj.com - Alpha Moon™ Instruction Manual Page 7
©
American DJ Supply
®
- www.americandj.com - Alpha Moon™ Instruction Manual Page 8
1. MINI/C Controller Jack
- This is for use the optional MINI/C Black
out controller only.
Do not attempt to connect an audio signal
this jack, this will damage the PC board and void your manufac-
tures warranty!
2. Dip Switches -
These switches are used to set the DMX address.
Each switch corresponds to a specific value based on binary code.
See page 6 for a detailed explanation of DMX binary code.
3. Cooling Fan -
Keep the fan grill clean. Never block the fan vents,
always allow at least four inches between the fan and any other sur-
face. Improper cooling may result in premature lamp failure.
4. Thumb Screw -
This screw hold the lamp cover in place. Remove
this screw to access the lamp compartment.
5. Power Indicator -
This LED will flash when it receives either an
audio or DMX signal.
6. XLR Output Jack -
This jack is used to send the incoming DMX
signal to another DMX fixture.
7. XLR Input Jack -
This jack is used to accept an incoming DMX
signal.
8. Power Cord -
Connect only to a matching power outlet. Never use
this fixture is the ground prong has been removed or broken off.
For a more dramatic effect, link several Alpha Moons together.
Alpha Moon™ Linking
Linking:
Your fixture comes with a built-in controller. This controller
may be used to control up to 16 units when daisy-chained together in
a master-slave configuration. Any unit can function as either a “Master
Unit” or a “Slave Unit.” Link the units together using standard DMX
cable.
Alpha Moon™ Controls and Functions
ON
1 2 3 4 5 6 7 8 9 10
1
9
8
7
6
5
4
3
2
11
10
