10
3.5 Connect with power
Connect the red wire to the
positive pole of the battery and connect the black wire to the
negative pole of the battery. Connect the yellow wire to the ignition signal of the vehicle. The fuse
should be connected to the positive pole and red wire. Please note: the fuse is used for protecting
the battery, so the fuse should be placed near to the battery positive pole.
NOTE
1. The DVR uses DC power input, please be very careful when connecting to the “+” and “-” of the
power supply.
2. Wide voltage range of 8V-32V for the DVR. The DVR may be damaged if the voltage comes too
high. And the DVR may not work if the voltage comes too low.
3. Power of the DVR should be supplied by the car battery.
4. Power consumption of the DVR can be 60W when the engine starts. All the cables for
connecting from power to the DVR should be thick enough for current over 5 Amperes.
5. To protect the battery from being damaged of short circuit, the fuse should be placed very
closed to the “+” pole of car battery.
3.6 GPS connection (Optional)
Connect the GPS Module to the GPS connector on the sensor cable harness.
