15
Make sure whether power switch is turned on or turned off, if it is turned on, please use the key, turn the
indentation on the “turn off” position.
"
Pull the front panel of the hard drive box. Carry out the hard drive and drop it on the table.
"
Set down the two screws of the hard drive by cross-screwdriver.
"
Drop the under backer of hard drive box, and then check the line whether it is on top of the under
backer or not.
"
Bring here the SATA hard drive which needs installation; connect the line joint of hard drive box
to the hard drive. Please note the heading of the line while connecting. Make sure all of the
connecting is complete done.
"
Put the hard drive in the hard drive box. The obligate line of hard drive needs longer, the line of
hard drive needs to lie on the right position.
"
Let the four white screws of the machine through the center hole of the four shockproof rubber
pads. Fix hard drive on the four holes of hard drive box, do not make the screws too taut, leave a
little space for hard drive to move. So it can reach a perfect effect.
"
Insert the hard drive under backer which has hard drive to the hard drive top backer, and then,
use cross screwdriver and the screw to fix the under backer and the top backer.
"
Aimed the hard drive box towards the groove of the front board, level push. Please note the face
and back while pushing. Upturn the silk-screen on the right position.
"
Wring the lock of the front board by key. Turn the groove on the “turn on” position, lock hard drive
box to prevent hard drive from moving out.
Note : Hard drive fixing lock besides fixing the hard drive, also take the place of host power switch .So
do this operation, make sure all lines are completely connected. Otherwise, if car‘s power have
been connected with the standard input voltage, the machine should be destroyed. So while
installation, if the line has not been completely connected, please stop to do this step. More
careful when installation. The hard drive can not roll out even it has not been locked.
6
Instruction of Using
6.1
Instruction of Front Panel
