©
American Audio
®
- www.americanaudio.com - WR 90E™ Instruction Manual Page 6
Transmitter Set Up
1. Unscrew the bottom part of the microphone. The battery connections are located inside of the
microphone.
2. Insert and connect two (2) fresh AA batteries into the battery connections.
3. Screw the bottom of the microphone back into place.
Receiver Set Up
1. Plug the included AC power supply into the DC input connector on the back of the receiver.
2. Plug the other end of the AC power supply into an AC power outlet.
Note: Make sure the volume on the receiver is turned all the way down befor switching on
the power.
Connecting the Receiver Output
1. You can connect the receiver to a output source using a cable with an 1/4’’ jack or 3-pin XLR
female connection.
2. Connect one end of the cable to the receiver, and the other end into the mic input of a mixer, PA
system, or amplifier.
WR 90E™
SYSTEM SET UP
WR 90E™
TRANSIMITTER CONTROLS AND FUNCTIONS
10. Low Battery LED -
This red LED will flash when the power is first switched on. The LED will
glow when the batteries are low.
11. ON/OFF Switch -
This is the main power switch for the transmitter. A red LED will flash indi-
cating that the transmitter is ON.
10
11
