13. Cooling Fans -
Dual high speed cooling fans
14. Channel 2 Subwoofer Mode On/Off Switch -
Turns the subwoofer
mode for channel two on and off.
15. Channel 2 Frequency Adjustment -
This knob is used to adjust the
frequency level sent to your speaker on channel two when running the
channel in subwoofer mode.
16. Channel 1 Frequency Adjustment -
This knob is used to adjust the
frequency level sent to your speaker on channel one when running the
channel in subwoofer mode.
17. Channel 1 Subwoofer Mode On/Off Switch -
Turns the subwoofer
mode for channel one on and off.
18. Channel 2 XLR THRU Jack -
This jack is used to send a parallel
signal from the channel two input jacks to another device or amplifier.
19. Mode Switch -
This switch controls the amplifier’s operating mode.
The amplifier can operate in three different modes; Mono Bridge, Parallel
Mono, or Stereo. The amplifier is shipped in stereo mode.
20. Channel 1 XLR THRU Jack -
This jack is used to send a parallel
signal from the channel one input jacks to another device or amplifier.
21. Reset Button -
This button is used to reset the breaker.
22. AC Cord -
Plug this cable into a standard 110~120v wall outlet.
Check that the voltage in your area matches the amplifiers required volt-
age. To get optimum power out of this particular amplifier, switch the
standard Edison plug to a 30 amp. plug. (See page 15)
23. Channel 1 TRS Input -
Channel one 1/4” female jack. Excepts either
a balanced or unbalanced plug. See page 7 for more details.
24. Channel 1 Output Jack/5 way Binding Post -
Connect to your
speaker’s input jack. Red is positive signal and Black is negative signal.
25. Channel 2 Output Jack/5 way Binding Post -
Connect to your
speaker’s input jack. Red is positive signal and Black is negative signal.
26. Channel 1 XLR input -
Channel one 3-pin XLR balanced input jack.
See page 7 for more details.
27. Channel 1 Speakon Output -
Optional speaker output connections.
Use pins 1+ and 1- of this 4-pole Speakon connector to connect to your
speaker’s Speakon input jack.
28. Channel 2 XLR Input -
Channel two 3-pin XLR balanced input jack.
See page 7 for more details.
29. Channel 2 Speakon Output -
Optional speaker output connections.
Use pins 1+ and 1- of this 4-pole Speakon connector to connect to your
speaker’s Speakon input jack.
30. Channel 2 TRS Input -
Channel two 1/4” female jack. Excepts either
a balanced or unbalanced plug. See page 7 for more details.
Diagram 2
13
13
20
19
18
17
16
15
14
23
22
21
29 28 27 26 25 24
30
©American Audio® - www.americanaudio.com - V5000plus™ Power Amplifier User Manual Page 6