GENERAL FUNCTIONS AND CONTROLS (Cont.) FRONT & REAR PANEL
©
American Audio
®
- www.AmericanAudio.us - CK 800Mp3 Instruction Manual Page 14
Figure 5
Figure 4
32
30
31
B. FRONT PANEL (FIGURE 4)
30. TRANSPORT TRAY 1 -
This tray is used
to load and unload a compact disc. The tray
is opened and closed by pressing the
oPEn/
CLOSE BUTTON (1). Never attempt to force the
transport tray open or closed when the power is
turned off.
31. HEADPHONE JACK -
This jack is used to
connect your headphones to the mixer allowing
you to monitor the cue source. Use headphones
only rated at 8 ohms to 32 ohms. Most DJ head-
phones are rated at 16 ohm, these are highly
recommended. Always be sure the
cue leVel
Volume (27)
is set to minimum before you put
the headphones on.
32. TRANSPORT TRAY 2 -
This tray is used
to load and unload a compact disc. The tray
is opened and closed by pressing the
oPEn/
CLOSE BUTTON. Never attempt to force the
transport tray open or closed when the power is
turned off.
C. REAR PANEL (FIGURE 5)
33. BALANCED xLR mASTER OUTPUTS
JACKS -
The Master Output includes a pair of
XLR Balanced jacks as well as a pair of
rca
unBalanced jackS (38)
. The 3-pin XLR jacks
send a high current balanced output signal.
These jacks should be used when you will be
driving an amp or other audio equipment with a
balanced input, or whenever you will be running
a signal line greater than 15 feet. Always, use
these jacks whenever possible.
34. DIGITAL OUT -
Use this connection to create
near perfect copies of your disc to a Mini disc,
CD-R, or any other digital recording device.
35. REC OUT -
This is a low current unbalanced
output source designed for various tape and CD
recorders. The Record Out (REC OUT) level is
dictated by the
channel fader leVel (22)
, it
is not influenced by the
maSter Volume con-
trol (28).
41
40
39
36 35 34
33
37
38
42
