AMEC CUBO-160, Manual

Page: 10 / 19

5
2.2.4 Connecting
After clarifying all definition of port on front panel, users can start install the equipments. The
step of connection shows as follows.
Step 1
: Connect the VHF antenna to the label “VHF ANT” Connector
Step 2 : Connect the VHF antenna output of VHF Radio to the
label “VHF Radio” Connector
Step 3
: Connect the VHF antenna output of AIS Transponder/Receiver to the label “AIS TX/RX”
Connector (Notice: Please use UHF Plug
– BNC Jack Adaptor to AIS
transponder/receiver if it is necessary)
Step 4 : Connect the Antenna Input of AM/FM Receiver
to the label “AM/FM” Connector
(Optional)
Step 5
: Connect power cable to the label “DC Power”
Step 6 : 12~24 VDC power supply to power cable.

The red wire should be connected to the positive power supply connection via 1A rated
fuse or circuit breaker.

The black wire should be connected to the negative supply connection.
Figure 2-2-3 Wiring definition in Power Cable
Step 4 (Optional):
Connect AM/FM Radio
Step 1:
Connect VHF Antenna
Step 2:
Connect VHF Radio
Step 3:
Connect AIS Transponder/Receiver
Step 5:
Connect Power Cable
VHF
ANT.
VHF
Radio
AIS
TX/RX
AM/FM
Radio
Step 6:
Connect 12V ~ 24V
power Supply